Skip to main content

Life keeps throwing columnist for a looper

The last couple of weeks seem to be filled with what could be called discontent. Not only does the weather keep bringing white stuff, in the middle of April, but little things keep going wrong, and I have to deal with getting them fixed. First it was the van. I am not out after dark very often with my vehicle, but one of those rare nights that I was, the dash lights were so dim that I could not tell how fast I was going. The gas gauge and other information was also not visible. It felt very much like I was driving in the dark, almost like a fog. I even wondered if the headlights were working, so I checked them and they seemed fine. However, no matter how I fiddled with the knob that adjusted the lights inside my vehicle, the dash lights were so dim that I couldn’t see the important information. I reached home safely, and must not have speeded, because I didn’t get a ticket. A few evenings later, I was also out after dark, and then there wasn’t even a dim light; it was just dark. That night I turned the ceiling light on long enough to know how fast I was going, so I could set the cruise and travel at a safe rate of speed. I could no longer deny that there was something wrong with my van, and that it needed repair, so I made an appointment. Was it a fuse or a bulb, I didn’t know. When I got to my local garage, he drove the van inside, and a couple of minutes later he backed it back out. He came in with a smile, and said that it is fixed. All he had to do was adjust the knob. The very same one I had been adjusting. I was relieved it wasn’t going to take a long time or cost money but confused about that knob setting being the problem. Now, I wonder if there could be a wire that might jiggle loose now and then. Guess only time will tell. My other problem is my surger, which is a type of a sewing machine. It has an upper looper, a lower looper and two needles that sew straight seams. I love my surger most of the time, but at this moment, it is having a temper tantrum. I was sewing around the edge of a mission quilt, when the inner needle hit too thick of fabric and broke. That caused the thread to break from the upper looper. I know how to thread the machine. I have had it for many years, and even though I only use it this time of year, for mission quilting, I still know how it is done. Besides, since all was failing, I even reviewed the instruction book. However, no matter how many times I have gone through the process of putting all the needed threads in the right places, in the right order, it lets me sew for a while and then breaks again. I remember it has done that sometimes in the past, so I am not going to be dismayed. As I have time, I am going to go down those stairs and try, try again. This next time I am going to try a new spool of thread in that spot, to see if that will help. Why use a surger when a sewing machine will do? Well, it is faster (unless thread is breaking), it is neater, and it is a pleasure to use, when it is working correctly.